6. Installing
To install Red Hat Linux via PLIP, simply choose to install via NFS or
FTP; when the installation program asks you to choose a network driver,
choose the PLIP driver.
Next, the installation program asks for networking information; here's
what to answer for heffa and lump:
IP address: 10.0.2.21_______ <--(this is lump)
Netmask: 255.255.255.255_
Default gateway (IP): 10.0.2.17_______ <--(this is heffa)
Nameserver: 10.0.2.1________ <--(our nameserver)
Make sure to use the correct IP addresses for your machine, your PLIP
server, and your nameserver.
The rest of the install should proceed the same as any other network-based
install.
--Researched by
George Beranek
Posted by
Connie Sieh